|
How to fix Dell printer error code 016-302
|
|
Has your device completely frozen, is not accepting the command and has just stopped printing pages. Then probably, it is an indication of error code 016-302 in your Dell printer. If you are looking for instant help to rectify this issue, then must surely read ahead without wasting a single time:
• Clear all the print jobs in the queue
• Make sure that you do not give multiple commands to the printer, in order to avoid this error in the future
• Reset the IP address or the network settings, and try installing the printer once again in the device
• Let the device cool down for a few minutes. Remove all the cables that have been attached to it. Switch it back after waiting for a few minutes
If these quick fixes just fail to prove efficacious, then you need to dial the Dell printer customer support number and have a word of discussion with the techies.
Read More:- https://www.customersupporthelpline.com/dell-customer-support/
|
| lisa paul 02/12/2019 05:50 |
|
| |
Adrian Gates |
06/23/2020 14:56 |
Steps to solve Error code 016-302 in Dell printers
Step 1: Firstly you have to remove any print command from the queue and you have to clear the path of the print in the queue and then try to reprint again.
Step 2: It is possible that if you have given multiple commands at the same time the print commands have been stuck in the queue and the device is not able to print the document so clean the queue and then print again.
Step 3: Changing the IP address of your Dell device will also help in troubleshooting the issue.
Step 4: To do so, you have to reset the network settings of the device and then add the printer again to your system or install it again if required.
Step 5: After that, go to the “printer settings” and then add the new IP address there
Step 6: It may be possible that due to over-heating the print commands have stuck in the queue and have resulted in the error. So turn the device off and wait for it to cool down, and if any paper is stuck in the printer then remove it when the printer cools down after turning it on.
Step 7: It may be possible that it is due to the outdated printer driver and firmware so make sure that you have the latest firmware and drivers installed on your printer.
Hope this helps.
Regards,
Adrian
Technical Consultant
https://www.apps4rent.com
https://www.clouddesktoponline.com
https://www.o365cloudexperts.com
|
|
Print